Example Of Creating A Vlan And Assigning Interfaces - Dell Force10 S2410-01-10GE-24P Configuration Manual

Example of creating a VLAN and assigning interfaces

The diagram in this example shows four S-Series switches, R1, R2, R3, and R4, each configured with
VLAN 2 to handle traffic destined for R1.
This example creates VLAN 2 to connect four switches, with each switch having an interface that connects
through VLAN 2 to switch R1.
Figure 14-168. VLAN Topology
1. Create VLAN 2 on switch R1 and assign ports 20, 22, and 23:
R1 #config
R1 (Config)#interface vlan 2
R1 (Conf-if-vl-2)#untagged 1/0/20
R1 (Conf-if-vl-2)#untagged 1/0/22
R1 (Conf-if-vl-2)#untagged 1/0/23
2. Create VLAN 2 on switch R2 and assign port 1:
R5 #config
R5 (Config)#interface vlan 2
R5 (Conf-if-vl-2)#untagged 1/0/1
3. Create VLAN 2 on switch R3 and assign port 3:
R3 #config
R3 (Config)#interface vlan 2
R3 (Conf-if-vl-2)#tagged 1/0/3
4. Create VLAN 2 on switch R4 and assign port 4:
R4 #config
R4 (Config)#interface vlan 2
R4 (Conf-if-vl-2)#untagged 1/0/4
5. Optionally, after creating the VLAN, you can name it using the
this example is providing access to the Internet, you might name the VLAN "Internet_through_R1" on
each participating switch.
212 | VLANs
VLAN 2
name command. For example, if R1 in