Using Show Commands For Stacking Information - Dell Force10 S2410-01-10GE-24P Configuration Manual

Using show Commands for Stacking Information

Use show
examples of using
•
show stack-port
•
show switch
Figure 5-59 on page
•
show supported switchtype
•
show bootvar
•
show stack
To show information about MAC addresses in a stack, use the
Figure 5-66. Using the show mac-addr-table Command Example
Force10 #show mac-addr-table
Mac Address
-----------------------
00:01:00:01:00:00:00:01
00:01:00:01:00:00:00:37
00:01:00:03:00:00:00:03
00:01:00:03:00:00:00:39
00:01:00:04:00:00:00:45
00:01:00:04:00:00:00:46
00:01:00:06:00:00:00:47
00:01:00:06:00:00:00:48
00:01:00:D0:95:B7:CD:2E
Note: The "0/3/1" in the Interface column references the CPU.
To show information about stack port status, use the
Figure 5-67. Using the show stack-port Command Example
Force10 #show stack-port
Unit
---- ---------------- ---------- ---------- ------------ ------------
1 Stack Port A
1 Stack Port B
2 Stack Port A
2 Stack Port B
To show activity at the stack ports, use the
98 | Stacking S-Series Switches
commands to gather information about stack members. In this chapter, see the following
show commands:
: See Figure 5-55 on page
: See Figure 5-56 on page
91.
: See
: See Figure 5-62 on page
: See Figure 5-65 on page 97
Interface IfIndex
---------
2/0/37
1/0/1
1/0/2
2/0/38
2/0/45
1/0/45
2/0/46
1/0/46
0/3/1
Configured
Stack
Interface Mode
N/A
N/A
N/A
N/A
88.
88, Figure 5-57 on page
Figure 5-57 on page 90.
96, Figure 5-63 on page
and Figure 5-70 on page
Status
------- ------------
87 Learned
1 Learned
2 Learned
88 Learned
95 Learned
45 Learned
96 Learned
46 Learned
401 Management
show stack-port
Running
Stack Link
Mode Status
Stack Link Down
Stack Link Up
Stack Link Up
Stack Link Down
show stack-port counters
90, Figure 5-58 on page
96, and Figure 5-64 on page
100.
command:
show mac-addr-table
command:
Link
Speed (Gb/s)
10
10
10
10
command:
91, and
97.