Important Points To Remember; Rmon Command Set; Configuring Rmon Alarms - Dell Force10 S2410-01-10GE-24P Configuration Manual

Alarm
(OID 1.3.6.1.2.1.16.3)
Events
(OID 1.3.6.1.2.1.16.9)
SFTOS does not support the RMON 1 MIB groups Host, HostTopN, Matrix, Filters, Packet Capture, or
Token Ring or the RMON 2 groups.

Important Points to Remember

• Collected data is lost during an S-Series chassis reboot.
• Only SNMP GET/GETNEXT access is supported. Configure RMON using the RMON commands.

RMON Command Set

For details on RMON command syntax, see the RMON chapter in the SFTOS Command Reference.
rmon alarm
1-65535 SNMP_OID 5-3600 {
0-4294967295 index
rmon collection history controlEntry
rmon collection statistics controlEntry
rmon event
1-65535
show rmon (See
show rmon alarms
show rmon events
show rmon history
show rmon log
show rmon statistics

Configuring RMON Alarms

The following steps create an RMON event ID and associates an alarm to it. The example (see
on page 78) following it shows the use of these commands.
Step Command Syntax
1
rmon event
[ trap SNMP_community
[ description string
[
owner name
76 | Management
Periodically takes statistical samples and compares them with set thresholds for events
generation — includes the alarm table and requires the implementation of the event group.
Alarm type, interval, starting threshold, stop threshold.
Controls the generation and notification of events from this device — event type,
description, last time event sent.
delta
[ owner ]
string
1-65535
[ log ] [ trap
SNMP_community
Figure 4-48 on page 78.)
and
show rmon alarms brief
and
show rmon events brief
and
show rmon history brief
and
show rmon log brief
and
show rmon statistics brief
Command Mode
Global Config
[ ]
log
1-65535
]
]
]
absolute rising-threshold
| }
[ buckets ] [
number
[ owner ]
1-65535 name
] [ description
string
Purpose
Add an event ID to the RMON Event Table.
0-4294967295 index
interval ] [ owner
5-3600
] [ owner ])
name
falling-threshold
]
name
Figure 4-48