Inspecting Management Preferences; Hardware Management Preference - Dell Force10 S2410-01-10GE-24P Configuration Manual

Figure 5-61. Moving the Management Unit Function within a Stack
Force10 (config-stack)#movemanagement 1 3
Moving stack management will unconfigure entire stack including all interfaces.
Are you sure you want to move stack management? (y/n) y
Force10 (config-stack)#
(Unit 1)>This switch is not manager of the stack.
STACK: detach 15 units
(Unit 1)>
(Unit 3)>
(Unit 3)>This switch is manager of the stack.
STACK: attach 5 units on 1 cpu
User:Trying to attach more units.....
This switch is manager of the stack.
STACK: attach 5 units on 1 cpu
Trying to attach more units.....
This switch is manager of the stack.
STACK: attach 5 units on 1 cpu
User:
User:*****
Password:
Force10 >enable
Password:
Force10 #show switch
Management
Switch Status
------ ------------ ------------- ------------- --------------------- --------
1 Stack Member SA-01-GE-48T
3 Mgmt Switch SA-01-GE-48T
4 Stack Member SA-01-GE-48T
Force10 #

Inspecting Management Preferences

The command show switch
about the Switch on page
Preference" and one called "Admin Management Preferences", as described here.

Hardware Management Preference

The "Hardware Management Preference" field indicates whether the device is capable of becoming a
management unit. The value for Hardware Management Preference always displays as "Unassigned." The
other valid value for this field is "Disabled". The attribute cannot be changed through the CLI.
Preconfig Plugged-in
Model ID Model ID
SA-01-GE-48T
SA-01-GE-48T
SA-01-GE-48T
(see an example in
number
32) generates a report that displays a field called "Hardware Management
Unit 1 no longer
has CLI
Log into Unit 3
Switch
Status
OK 2.3.1.5
OK 2.3.1.5
OK 2.3.1.5
Figure 5-56 on page 88; see also
Code
Version
Management
Switch is now
Unit 3
Verifying Details
Stacking S-Series Switches | 93