Dell Force10 S2410-01-10GE-24P Configuration Manual page 115

Switch
Force10 #show interface ethernet switchport
Total Packets Received (Octets)................ 0
Unicast Packets Received....................... 0
Multicast Packets Received..................... 0
Broadcast Packets Received..................... 0
Receive Packets Discarded...................... 0
Octets Transmitted............................. 0
Packets Transmitted Without Errors............. 0
Unicast Packets Transmitted.................... 0
Multicast Packets Transmitted.................. 0
Broadcast Packets Transmitted.................. 0
Transmit Packets Discarded..................... 0
Most Address Entries Ever Used................. 1
Address Entries Currently in Use............... 1
Maximum VLAN Entries........................... 1024
Most VLAN Entries Ever Used.................... 1
Static VLAN Entries............................ 1
Dynamic VLAN Entries........................... 0
VLAN Deletes................................... 0
Time Since Counters Last Cleared............... 0 day 0 hr 25 min 45 sec
Force10 #
The
show interfaces cos-queue
the same report — one version for the interface and the other for the switch. The version of the report
generated with the
unit/slot/port
Figure 7-81. Using the show interfaces cos-queue Command for Port QoS Details
Force10 #show interfaces cos-queue 1/0/1
Interface...................................... 1/0/1
Interface Shaping Rate......................... 0
Queue Id Min. Bandwidth
-------- --------------
0 0
1 0
2 0
3 0
4 0
5 0
6 0
Force10 #
Use the
show interface ethernet
port, as shown in Figure 7-82 on page
[ ], with and without the
unit/slot/port
parameter is shown in Figure
Scheduler Type Queue Management Type
-------------- ---------------------
Weighted Tail Drop
Weighted Tail Drop
Weighted Tail Drop
Weighted Tail Drop
Weighted Tail Drop
Weighted Tail Drop
Weighted Tail Drop
command for detailed packet information for the designated
unit/slot/port
116.
parameter, produces almost
unit/slot/port
7-81.
Configuring Interfaces | 115