Example Of Adding A Lag To A Vlan - Dell Force10 S2410-01-10GE-24P Configuration Manual

Example of adding a LAG to a VLAN

Figure 14-171. Adding a LAG to a VLAN
1. To create the topology shown in
(and, optionally, a description — the "admin1" shown here). Add ports to it, and enable it (use either
the no shutdown
here).
Figure 14-172. Creating a LAG and Adding Ports
R1 (Config)#interface port-channel 1
R1 (conf-if-po- 1)#description "admin1"
R1 (conf-if-po- 1)#channel-member 1/0/35-1/0/37
R1 (Config)#exit
R1 (Config)#port-channel enable all
2. Create VLAN 300 and add the LAG to it on switch R1.
Figure 14-173. Adding a LAG to a VLAN
R1 (Config)#interface vlan
R1 (Conf-if-vl-300)#tagged port-channel 1
3. Repeat the above sequence on switch R2.
4. Verify the operation on both switches.
Figure 14-174. Verifying a LAG in a VLAN with show vlan id and show port-channel id
R2 #show vlan id 300
Codes: * - Default VLAN, G - GVRP VLANs, E - Ethernet interface
Vlan Id
-------
300
R2 #show interfaces port-channel brief
LAG Status Ports
--- ------ -------
1 Down
216 | VLANs
Figure
command inside the Interface Port Channel mode, or use the global mode shown
300
Status Q Ports
--------- - --------
Active T Po1
1/0/35 (Down)
1/0/36 (Down)
1/0/37 (Down)
14-171, create the LAG on switch R1, giving it an integer ID