Vlan Routing Rip Configuration - Dell Force10 S2410-01-10GE-24P Configuration Manual

Figure 17-249. Output of the show ip ospf interface vlan Command
Force10 #show ip ospf interface vlan 10
IP Address..................................... 10.1.1.1
Subnet Mask.................................... 255.255.255.0
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.2
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ MD5
Authentication Key............................. "force10"
Authentication Key ID.......................... 10
Metric Cost.................................... 1
OSPF Mtu-ignore................................ Disable
OSPF Interface Type............................ broadcast
State.......................................... backup-designated-router
Designated Router.............................. 2.2.2.2
Backup Designated Router....................... 1.1.1.1
Number of Link Events.......................... 3
Force10 #

VLAN Routing RIP Configuration

The two versions of the Routing Information Protocol (RIP) are described in
page 255. The following example demonstrates how to add support for RIPv2 to the configuration created
in the previous base VLAN routing example
page 263). A second router, using port routing rather than VLAN routing, has been added to the network.
Figure 17-250. RIP for VLAN Routing Example Network Diagram
(computed)
(Example of creating a routed VLAN between switches on
RIP Configuration on
Layer 3 Routing | 267