Dell Force10 S2410-01-10GE-24P Configuration Manual page 25

Sftos configuration guide
Hide thumbs Also See for Force10 S2410-01-10GE-24P:
Table of Contents

Advertisement

Displaying the MAC address table: Both FTOS and SFTOS have the
command, but the SFTOS command provided different results than the FTOS command before
SFTOS Release 2.3. The SFTOS syntax still contains the unit/slot/port form cited above, for example,
show mac-addr-table interface 1/0/4.
Displaying port information: FTOS and SFTOS have different sets of the
interfaces
commands. SFTOS also has a similar
up or not, as shown in
Figure 2-1. Using the show port
(Force10 S50) #show port 1/0/2
Admin
Intf
Type
Mode
------ ------ ------- ---------- ---------- ------ ------- -------
1/0/2
Enable
(Force10 S50) #
Displaying system information: The FTOS command
SFTOS, which shows basic information, including the running software version and up time. Other
similar commands in SFTOS are
the results of a group of those similar commands.
The
terminal length
in SFTOS before SFTOS Release 2.3.
The
service timestamps
timestamps automatically.
OSPF area ID: In SFTOS, OSPF only accepts the IP address format for the area ID, not the number
within a range.
File management:
Table 2-1. Switch File Management
FTOS references system file locations as: SFTOS references system file locations as:
flash://
slot0://
Management address: SFTOS Release 2.3 modifies the creation of a management address to be more
like FTOS, but there are still some differences.
Setting the size of the logging buffer: The FTOS command
enables you to set the size of the buffer, while SFTOS does not. Both FTOS and SFTOS invoke debug
logging with the number 7 as the severity level parameter. For example, the SFTOS command is
.
logging buffered 7
Figure
2-1:
Command
Physical
Physical
Mode
Status
Auto
show hardware
command: This FTOS command (often shortened to "
command: This FTOS command is not available in SFTOS. SFTOS sets
show port
command for displaying whether a port is
Link
Link
LACP
Status
Trap
Mode
Down
Enable
Enable
show linecard
and
, and
show sysinfo
nvram:
system:
logging buffered
show mac-address-table
and
show interface
is similar to
show version
provides
show tech-support
") was not available
term len
has a parameter that
SFTOS Features | 25
show
in

Advertisement

Table of Contents
loading

This manual is also suitable for:

Force10

Table of Contents