Management; Creating The Management Ip Address - Dell Force10 S2410-01-10GE-24P Configuration Manual

Management

This chapter covers the following management tasks:
•

Creating the Management IP Address

• Changing the Management VLAN from the Default on page 68
• Verifying Access to a Management Port on page 69
• Verifying Management Port Connectivity on page 69
• Setting Stack Management Preferences on page 69
• Setting the Host Name Prompt on page 70
• Restoring the Configuration to Factory Defaults on page 70
• Setting up SNMP Management on page 71
• Link Layer Discovery Protocol (LLDP) on page 75
• Setting up Remote Network Monitoring (RMON) on page 75
• Setting the System Date and Time on page 78
• Gathering Details about the Switch on page 81
Creating the Management IP Address
The procedure for creating the management IP address is introduced in
Address on page 39
Figure 4-39. Creating the Management Port IP Address
Force10 (Config)#management route default 10.10.1.254
Force10 (Config)#interface managementethernet
Force10 (Config-if-ma)#ip address 10.10.1.251 255.255.255.0
Force10 (Config-if-ma)#exit
Force10 (Config)#exit
Force10 #show interface managementethernet
IP Address..................................... 10.10.1.151
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.10.1.254
Burned In MAC Address.......................... 00:01:E8:D5:A0:39
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1
Web Mode....................................... Disable
Java Mode...................................... Disable
in the Getting Started chapter.
Setting the Management IP
Figure 4-39 shows the use of that procedure:
4
Management | 67