The CLI commands in the Interface Port Channel Config mode include the following:
•
Add to the selected LAG (or delete from it), one or more ports:
— [
]
no
channel-member
•
Enter a description for the selected LAG:
— [
]
no
description
•
Configure the priority for untagged frames:
— dot1p-priority
•
Set the maximum transmission unit (MTU) size (in bytes) for the selected LAG:
— [
]
no
mtu
•
Attach a specified ACL to the selected LAG (and, optionally, to also enter a sequence number (from
1-4294967295) that indicates the order of this ACL relative to other ACLs assigned to this LAG):
—
ip access-group
•
Attach a MAC ACL identified by
option is as described above:
—
mac access-group
•
Enable the support of static link aggregations on the LAG. By default, the static capability for all LAGs
is disabled:
— protocol static
•
Reenable the LACP on the selected LAG:
— protocol lacp
•
Enable or disable the LAG:
— [
no
]
shutdown
•
Enable or disable link status traps for the LAG:
— [
]
no
snmp trap link-status
•
Set the spanning-tree operational mode on the selected LAG:
— [
]
no
spanning-tree
•
Set or clear the CST cost for the LAG:
— [
]
no
spanning tree 0 cost
•
Set or clear the CST priority for the LAG.
— [
no
]
spanning tree 0 priority
•
Associate or disassociate a multiple spanning tree instance with cost to the LAG:
— [
no
]
spanning-tree MSTi
•
Set or clear the priority associated with the multiple spanning tree instance for the LAG.
— [
]
no
spanning-tree MSTi
•
Enable or disable spanning-tree MSTP edge-port mode:
— [
]
no
spanning-tree mstp edge-port
unit/slot/port
0-7
1518-9216
[
1–199
1-4294967295
to the selected LAG in the ingress direction. The
name
[
name
1-4294967295]
1-65535
0-15
cost
0-63
priority
0-63
–
,
unit/slot/port
unit/slot/port
]
in
1-2000000
0-240
1-4294967295
Link Aggregation | 169