Bulk Configuration Examples; Configure A Single Range; Configure Multiple Ranges - Dell Force10 S2410-01-10GE-24P Configuration Manual

Bulk Configuration Examples

The following examples are of using the

Configure a single range

In this example, the
interface range ethernet
member 5. Then, the
no shutdown
Figure 7-90. Using Bulk Configuration on a Single Range
Force10 (config)#interface range ethernet 5/0/1-5/0/23
Force10 (config-if-range-et-5/0/1-5/0/23)#no shutdown
Force10 (config-if-range-et-5/0/1-5/0/23)#
Note that spaces are not allowed around hyphens when specifying the range.
The resulting prompt includes interface types with slot/port information for valid interfaces, in this case
(conf-if-range-et-5/0/1-5/0/23)#. The prompt allows for a maximum of 32 characters. If the bulk
configuration exceeds 32 characters, it is represented by an ellipsis ( ... ).

Configure multiple ranges

In this example, the
interface range ethernet
configure the speed of the specified range of ports.
Figure 7-91. Using Multiple Ranges
Force10 (conf)#interface range ethernet 2/0/1-2/0/10,3/0/1-3/0/10
Force10 (conf-if-range-et-2/0/1-3/0/10)#speed 100 full-duplex
Note that spaces are also not allowed around commas when specifying the range.
If the interface range command specifies multiple port ranges, the resulting prompt displays the low and
high ends of the range. Similarly, if overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
command for bulk configuration.
interface range
command was used to select ports 1 through 23 on stack
range
command enabled all of those ports.
command was used to select multiple ranges in order to
range
Configuring Interfaces | 127