Stopping the mirroring session and removing probe and mirrored ports
Figure 16-213. Command Examples: Removing port mirroring configuration
Force10 (Config)#no monitor session 1 mode
Force10 (Config)#no monitor session source
Force10 (Config)#no monitor session destination
Force10 (Config)#no monitor
Note: Alternatively, you can use the no monitor command to disable port mirroring, which
automatically removes the mirror and probe configuration from the source and destination
ports. Then, reenabling port mirroring requires designating the source and destination ports
again.
Verifying Port Mirroring
Use the following commands from the Privileged Exec mode to inspect port mirroring settings:
•
show monitor session 1
•
show port all
•
show running-config
•
show port
Verifying port mirroring session status
Figure 16-214. show monitor session 1 Command Output
Force10 #show monitor session 1
Session ID
----------
1
In
Figure
244
|
Port Mirroring
: See
: See
Figure 16-214
: See
Figure 16-216
: See
Figure 16-217
Admin Mode
Probe Port
----------
----------
Enable
2/0/26
1/0/11
16-214, note that the probe (destination) port and mirrored ports are in different stack members.
Figure 16-214
Mirrored Port
-------------
1/0/1