Example #5: Show Sntp Server; Gathering Details About The Switch - Dell Force10 S2410-01-10GE-24P Configuration Manual

Example #5: show sntp server

Figure 4-53. Using the show sntp server Command
Force10 #show sntp server
Server IP Address: 10.11.8.6
Server Type: ipv4
Server Stratum: 3
Server Reference Id: NTP Srv: 128.4.1.2
Server Mode: Server
Server Maximum Entries: 3
Server Current Entries: 1
SNTP Servers
------------
IP Address: 10.11.8.6
Address Type: IPV4
Priority: 1
Version: 4
Port: 123
Last Update Time: JUNE 18 04:59:13 2005
Last Attempt Time: JUNE 18 11:59:33 2005
Last Update Status: Other
Total Unicast Requests: 1111
Failed Unicast Requests: 361

Gathering Details about the Switch

In addition to the
Switch on page 32
gathering typical switch information. See also the section
on page 98 in the Stacking chapter.
commands demonstrated in this chapter, the section
show
in the Getting Started chapter contains a good summary of
Verifying Details about the
show
Using show Commands for Stacking Information
commands useful for
Management | 81