Monitoring Igmp Snooping - Dell Force10 S2410-01-10GE-24P Configuration Manual

set igmp maxresponse 1–3599 (typically, 1 less than group membership
interval)
set igmp mcrtexpiretime all 0-3600

Monitoring IGMP Snooping

As shown in the following sample Telnet output, use the
Privileged Exec mode to inspect your settings.
Figure 15-202. Report from show igmpsnooping Command
Force10 #show igmpsnooping ?
<cr>
<unit/slot/port>Enter interface in unit/slot/port format.
mrouter Display IGMP Snooping Multicast Router information.
<1-3965>Display IGMP Snooping valid VLAN ID information.
Force10 #show igmpsnooping
Admin Mode................................Enable
Multicast Control Frame Count.............0
Interfaces Enabled for IGMP Snooping......1/0/10
Vlans enabled for IGMP snooping...........20
For IGMP details on a specific interface, use the
Figure 15-203 on page
238 | IGMP Snooping
— Default 10 seconds
—
set igmp maxresponse all 1–3599
— Both commands are issued from the Global Config mode.
— Default 0 seconds (no expiration)
— The command (Global Config mode) sets the time for all interfaces.
Press Enter to execute the command.
239.
sets the maximum response time on all interfaces
show igmpsnooping
show igmp interface
unit/slot/port
command from the
command, as shown in