Clearing The Running Configuration; Saving The Startup Configuration To The Network - Dell Force10 S2410-01-10GE-24P Configuration Manual

When the switch is booted, its configuration is managed by the startup configuration ("startup-config") file
that is stored in non-volatile memory (NVRAM). As you make configuration changes, those changes are
stored in volatile system memory as the "running config" until you copy them to the startup-config. The
quickest way to do that is to use the
You can also use the command
Saving the Running Configuration on page
Beginning with SFTOS Version 2.3, making changes to the startup-config file causes that file to be stored
as a text file. A major benefit of that text file, in addition to faster reboots, is that you can edit the file after
you copy it to a TFTP server. You can then download the edited file to any switch to use as the
startup-config file.
Caution:
Beginning with Version 2.3, the following commands must be present and occur in the same
relative locations in the startup-config file as if they had been automatically generated. Failure to do so will
result in unpredictable behavior:
interface vlan
vlan configuration commands
exit
configure
stack member commands (for example
exit

Clearing the Running Configuration

When downloading the startup-config file to the system from a TFTP server, the file will not take effect as
the startup configuration of the switch until a reboot (
of using the
clear config
downloaded startup-config without rebooting the switch. For details in this chapter on using script
commands, see Using Configuration Scripts on page
The following example shows the
Figure 3-28. Clearing the Running Configuration
Force10 #clear config
Are you sure you want to clear the configuration? (y/n)y
Clearing configuration. Please wait for login prompt.
Force10 #
(Unit 1)>

Saving the Startup Configuration to the Network

The following is an example of how to save the startup configuration to a TFTP site on the network.
write memory
copy system:running-config nvram:startup-config
49.
vlan id
command, followed by the
command for clearing the running-config from memory:
clear config
command (executed from the Privileged Exec mode).
member
unit switchindex
) is performed. However, you have the option
reload
script apply startup-config
60.
. For more detail, see
)
command to use the newly
Getting Started | 57