Dc Power Harnesses - HP Surestore Disk Array 12h - And FC60 Service Manual
Hp surestore e disk array fc60 service manual
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
DC Power Harnesses
The controller enclosure contains three DC Power harnesses
one +12 VDC. The power harnesses provide power connections between the power
interface board and the controller enclosure backpanel (midplane). Removal and
replacement of these harnesses requires removal of the controller enclosure from the rack.
To replace the DC power harnesses, complete the following steps:
+5 VDC Power Harnesses
Figure 121
DC Power Harnesses
1.
Remove the controller enclosure from the rack. See
2.
Remove the harness cover plate. See
3.
Disconnect the harness connectors from both the controller rear shield and the power
supply cage/midplane assembly and remove the cable(s) from the enclosure.
Internal Controller Enclosure Assemblies
350
(Figure
+12 VDC Power Harness
"Controller Enclosure" on page
"Harness Cover Plate" on page
121): two +5 VDC and
342.
349.
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?
Questions and answers