HP Surestore Disk Array 12h - And FC60 Service Manual page 232

Table 30
Controller Status LEDs codes (cont'd)
Code Description
0x6C Drive SCSI Channel 1
0x01 Turnaround diagnostics running
0x6C Drive SCSI Channel 2
0x02 Turnaround diagnostics running
0x6C Drive SCSI Channel 3
0x03 Turnaround diagnostics running
0x6C Drive SCSI Channel 4
0x04 Turnaround diagnostics running
0x6C Drive SCSI Channel 5
0x05 Turnaround diagnostics running
0x6E Passive controller - Normal during Firmware download. The controller may be in this
0xEE state after power ON (in this case, use the AM60 software to set to "Active" state).
0x80 In-between programming steps
0x80 Active controller - Normal State
0x00
0x81 Erasing boot flash segments
0x82 Writing boot flash segments
0x83 Verifying erase of boot segments
0x84 Verifying write of boot segments
0x89 Erasing file flash segments
0x8A Writing file flash segments
0x8B Verifying erase of file flash
segments
0x8C Verifying write of file flash
segments
Controller Enclosure Troubleshooting
232
Comments Cause / Solution
HW Diag. status Controller module /
reseat or replace
Firmware file is bad /
Download Firmware
with a good file.
Firmware file is
downloading or
Firmware file is bad /
Download Firmware
with a good file.