A - mezzanine board
B - backplane
C - pin connector
Figure 102
Disk Enclosure Mezzanine Assembly Removal and Replacement
4.
If you are removing the backplane:
a. Remove screw from the cam handle, open the handle, and pull power supplies free
of the backplane (see p. 298).
b. Loosen locking screws, open extractors, and pull BCCs free of the backplane. See
"BCC Module Removal/Replacement" on page
There is no need to loosen the fans.
Note
c. Remove the ten T-15 screws along the top and bottom edges of the backplane. See
Figure
103.
d. Pull the backplane forward to clear alignment pins (B) and lift the backplane up and
out of the disk enclosure.
300.
Internal Disk Enclosure Assemblies
315
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?
Questions and answers