HP Surestore Disk Array 12h - And FC60 Service Manual page 299
Hp surestore e disk array fc60 service manual
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
A - cam handle
B - locking screw
C - power supplies
D - power supply slot
Figure 94
Disk Enclosure Power Supply Module Removal and Replacement
Installing the Power Supply Module
1.
With the handle down, slide the replacement power supply into the empty slot (D in
Figure
94). The supply begins to engage the backplane with 3/8 inch (8 mm) still
exposed.
2.
Swing the handle upward to seat the power supply into the backplane. The power
supply should be flush with the chassis.
3.
Tighten the screw (B) in the power supply handle (A ).
4.
Plug the power cord into the power supply and electrical source.
5.
Check the Power Supply LED. It should then turn green. If the LED remains off or is
amber, see chapter 6, Troubleshooting for information on identifying and solving the
problem.
Disk Enclosure Modules
299
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?
Questions and answers