Disk Module Carrier Removal/Replacement - HP Surestore Disk Array 12h - And FC60 Service Manual

Disk Module Carrier Removal/Replacement

If the disk module carrier has been damaged, it can be replaced without replacing the disk
drive inside. If the damage to the carrier is a result of dropping it, the disk drive inside may
be damaged as well. Disk carriers must be replaced by a trained service representative
only.
Touching the disk circuit board can cause high energy
C
AUTION
discharge and permanently damage the disk.
Disks are fragile and should be handled carefully
Dropping or mishandling the disk may damage it.
If the disk is still in the disk enclosure, remove the disk module. See
Module or Filler Module" on page
1. Put the ESD strap on your wrist and attach the free end to an appropriate ground.
Failure to protect against ESD can result in the loss of all current data as well
C
AUTION
as the ability to store any future data on the disk.
2. Set the disk module, circuit-side down, on an ESD mat. Standoffs (E in
circuits away from the table surface.
Internal Disk Enclosure Assemblies
318
292.
.
"Removing a Disk
Figure 104) keep