Overview - HP Surestore Disk Array 12h - And FC60 Service Manual

Overview

This chapter describes removal and replacement procedures for the field replaceable units
(FRUs) for both the disk enclosure and the controller enclosure. Replacement procedures
for the disk enclosure FRUs are presented first, followed by the controller enclosure. Each
section is divided into two subsections: modules which can be replaced without hardware
disassembly, followed by internal assemblies which require some disassembly of the
enclosure. Table 40 lists the procedures in the order they are presented.
What is a "hot-swappable" component?
Note
The term hot-swappable identifies a component that can be removed and
replaced without disrupting host access to the disk array. Host I/Os continue
without interruption when replacing a hot-swappable component. Disk array
controller modules, disk modules, power supply modules, and fan modules are
all hot swappable components.
Is the HP SureStore E Disk Array FC60 customer repairable?
Note
Although the modular design of the Disk Array FC60 makes it easy to replace
failed components, it is recommended that repair of the product be done by a
trained service representative. This includes troubleshooting, and removal and
replacement of hot-swappable components. Customer repair should be
performed only in situations where a representative is not available, or system
operation may be impacted if repair is not performed immediately.
The HP SureStore E Disk Array FC60 is fully covered by a warranty from
Hewlett-Packard. Additional support services may have also been purchased
for the disk array. During the warranty period, or if the product is covered by a
service contract, it is recommended that you contact your service
representative for all service and support issues.
Overview
288