HP Surestore Disk Array 12h - And FC60 Service Manual page 221
Hp surestore e disk array fc60 service manual
Hide thumbs
Also See for Surestore Disk Array 12h - And FC60:
- Service manual (746 pages) ,
- Advanced user's manual (466 pages) ,
- User manual (310 pages)
Table of Contents
Advertisement
These status codes are displayed only momentarily and are typically not visible
Note
if the controller is operating normally. They are only visible if the firmware
"hangs" while executing these functions.
ernel Initialization
K
After the hardware is initialized, and the Boot Menu has been given a chance to be invoked,
the controller will initialize the kernel as the final part of the Boot Firmware initialization.
Table 30
lists the status codes that are displayed.
These status codes are displayed only momentarily and are typically not visible
Note
if the controller is operating normally. They are only visible if the firmware
"hangs" while executing these functions.
Table 30
lists the LED patterns while diagnostics are run, or when diagnostic failures occur.
Firmware Download / Flash Programming Patterns
The controller displays specific LED patterns during firmware download.
If firmware is being downloaded to the controller, the LEDs are all turned ON one by one,
until all LEDs are on. They are then all turned OFF one by one. The speed at which the
LEDs are turned ON or OFF depends on the rate at which code is being downloaded. The
LED pattern displayed is shown in
Note that a
Note
Table 27
Firmware Download LED Patterns
0x01
0x03
0x07
0x0F
0x1F
Table
27.
! ! ! ! indicates the LED is On or Flashing.
Controller Enclosure Troubleshooting
221
Advertisement
Table of Contents
Troubleshooting
