SureStore E Disk System SC10 Troubleshooting
The following steps should be performed in the indicated sequence when isolating
problems with the Disk System SC10 enclosure:
1.
Gather information from the following sources:
– Hardware Event notifications
–
LED status indicators
– Online status information and error logs (SAM/STM)
2.
Isolate the cause of the problem.
3.
Correct the problem. If it is necessary to replace a component, see
Replacement" on page
4.
Verify that the disk array is operational using IOSCAN or other host utilities.
Disk Enclosure LEDs
Figure 89
shows the locations of the disk enclosure status LEDs.
operating LED states for all components within the disk enclosure.
287.
SureStore E Disk System SC10 Troubleshooting
"Removal and
Table 38
summarizes the
281
Need help?
Do you have a question about the Surestore Disk Array 12h - And FC60 and is the answer not in the manual?
Questions and answers