Table of Contents
Advertisement
Crypto Map Mode Commands
set security-association level per-host
This command specifies that separate IPSec Security Associations (SAs) should be requested for
each source/destination host pair.
Syntax
set security-association level per-host
Syntax of the "no" Form
The no form specifies that one SA should be requested for each crypto map ACL permit entry.
no set security-association level per-host
Default
For a given crypto map, all traffic between two IPSec peers matching a single crypto map ACL
permit entry will share the same SA.
Mode
Crypto Map configuration:
Example
The following example sets the SA request on a per‐host basis:
XSR(config)crypto map ACMEmap
XSR(config-crypto-m)#set security-association level per-host
set transform-set
This command specifies which transform‐sets can be used with the crypto map entry.
Syntax
set transform-set transform-set-name1 [transform-set-name2...transform-set-name6]
transform-set-name
Syntax of the "no" Form
The no form of this command removes all transform‐sets from a crypto map entry:
no set transform-set
Mode
Crypto Map configuration:
14-114 Configuring the VPN
XSR(config-crypto-m)#
Name of the transform‐set. Up to 6 can be specified.
XSR(config-crypto-m)#
Advertisement
Table of Contents
