Enterasys X-Pedition XSR CLI Cli Reference Manual page 293

Syntax of the "no" Form
The no form of this command removes the specified neighbor:
no neighbor {ip-address | peer-group-name} maximum-prefix value [threshold]
[warning-only]
Mode
Router configuration:
Defaults
• No restriction on the number of prefixes.
• Threshold: 75 prefixes
Example
The following example sets the maximum number of prefixes allowed from the neighbor at
192.168.1.1 to 10000:
XSR(config)#router bgp 100
XSR(config-router)#neighbor 192.168.1.1 remote-as 101
XSR(config-router)#neighbor 192.168.1.1 maximum-prefix 10000
neighbor next-hop-self
This command disables automatic next‐hop selection. Updates meant for the specified system or
peer group are forced to advertise this router as the next hop.
Syntax
neighbor {ip-address | peer-group-name} next-hop-self
ip-address
peer-group-name
Syntax of the "no" Form
The no form of this command returns to the default value:
no neighbor {ip-address | peer-group-name} next-hop-self
Mode
Router configuration:
Default
Next hop selection is performed automatically by BGP.
XSR(config-router)#
Neighbor's IP address.
BGP peer group by name. Range: 1 to 64 characters.
XSR(config-router)#
BGP Configuration Commands
XSR CLI Reference Guide 6-97