Enterasys X-Pedition XSR CLI Cli Reference Manual page 369

Syntax of the "no" Form
The no form of this command removes PPP debugging on the interface:
no ppp debug packet
Default
Limit: 100 packets
Mode
Interface configuration:
Example
This example sets PPP debugging of IPCP and LQM packets with a 50‐packet limit on Serial 1/0:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation ppp
XSR(config-if<S1/0>)#ppp debug packet limit 50 ipcp lqm
Sample Output
The following debugging output is displayed on Multilink interface 57:
XSR#show interface multilink 57
********** Multilink Interface Stats **********
Multilink 57 is Admin Up
Internet address is 192.168.34.1, subnet mask is 255.255.255.0
LCP
IPCP
Multilink
Detailed Debug PPP Control Packet is ON for [type1] [type2] [type3], limit is [x],
number decoded is [y]
clear ppp
This command clears PPP counters for interfaces running PPP.
Syntax
clear ppp
Mode
Privileged EXEC:
Sample Output
The following output displays when you enter the
the serial 1/0:0 port:
XSR(config-if<xx>)#
State: OPENED
State: OPENED
State: OPENED
XSR#
PPP Debug, Clear and Show Commands
show ppp interface
XSR CLI Reference Guide 8-99
command after clearing