Table of Contents
Advertisement
Example
The following example specifies 11.12.1.99 as the IP address of the DNS server of a client in the
subnet:
XSR(config-dhcp-pool)#dns-server 11.12.1.99
The following example specifies 11.12.1.99 as the IP address of the DNS server of the host with the
MAC address 1111.2222.3333:
XSR(config-dhcp-pool)#hardware-address 1111.2222.3333
XSR(config-dhcp-host)#dns-server 11.12.1.99
The following example specifies 11.12.1.99 as the IP address of the DNS server of a client in the
client‐class engineering:
XSR(config-dhcp-pool)#client-class engineering
XSR(config-dhcp-class)#dns-server 11.12.1.99
domain-name
This command specifies the domain name for DHCP client services by the DHCP server.
Depending on the client configuration inheritance, the command should be used from the proper
mode. If it is specified from multiple modes, an override mechanism chooses the innermost config
value, with host as innermost, then client‐class and pool as the most general.
Syntax
domain-name domain
domain
Syntax of the "no" Form
Use the no form of this command to remove the domain name:
no domain-name
Mode
Any of the following command modes are available:
DHCP pool configuration:
DHCP host configuration:
DHCP client class configuration:
Examples
The following example specifies enterasys.com as the domain name of a client in the subnet:
XSR(config-dhcp-pool)#domain-name enterasys.com
The following example specifies enterasys.com as the domain name of the host with the MAC
address 0011.a121.1fa2:
XSR(config-dhcp-pool)#hardware-address 0011.a121.1fa2
XSR(config-dhcp-host)#domain-name enterasys.com
Domain name string of the client.
XSR(config-dhcp-pool)#
XSR(config-dhcp-host)#
XSR(config-dhcp-class)#
DHCP Commands
XSR CLI Reference Guide 15-89
Advertisement
Table of Contents
