Enterasys X-Pedition XSR CLI Cli Reference Manual page 466

Enterasys security router reference guide
Table of Contents

Advertisement

ISDN Commands
Example
The following example sets up a test call on channel 24 on BRI port 1/1:
XSR#isdn disconnect 1/1 24
<186>Jul 28 22:49:51 10.10.10.20 ISDN:
No Channel Available For Test Call
isdn spid1, isdn spid2 (BRI)
This command specifies the Service Profile Identification Number (SPID) which is supplied by 
your ISDN service provider.
North America (NOAM) ISDN switches use Fully Initializing Terminals (FIT) service which 
require the CPE to register its SPID with the Central Office (CO) before service can begin.
Syntax
isdn spid1 spid-number {max digits| ldn} {max digits}
isdn spid2 spid-number {max digits} ldn} {max digits}
spid-number
ldn
Syntax of the "no" Form
The no form of this command removes the SPID number:
no isdn spid1 {max digits| ldn} {max digits}
no isdn spid2
Mode
BRI Interface configuration: 
Example
The following example specifies a SPID and LDN for the B1 channel:
XSR(config-if<BRI-2/1>)#isdn spid1 508876123401 5088761234
isdn switch-type (BRI/PRI)
This command sets the central office switch type for the ISDN port, and triggers the creation of the 
following three dedicated serial interfaces: slot/card/port:0, slot/card/port:1 and slot/card/port:2 for the 
D, B1 and B2 channels, respectively. Because this command does not have a no form, you can only 
replace the switch with another, not remove it. The 
interface status.
11-88 ISDN BRI and PRI Commands
Number of the service to which you have subscribed, up to 26 digits. Assigned 
by the ISDN service provide, it is a 7 to 10‐digit phone number with additional 
prefix and suffix digits such as 905361707001.
If a SPID is set to 0 and the no isdn autodetect command was issued 
(autodetect not active), then the line is assumed to be No FIT type and will not 
attempt registration with the CO.
This Local Directory Number is a 7 or 10‐digit number assigned by the service 
provider. It is also used for setting the calling number for outgoing calls.
XSR(config-if<BRI-x>)
show interface
command displays the ISDN 

Advertisement

Table of Contents
loading

This manual is also suitable for:

X-pedition xsr

Table of Contents