Ip Rip Send Version - Enterasys X-Pedition XSR CLI Cli Reference Manual

RIP Commands

ip rip send version

This command sets RIP v1 or v2 for update packets sent on the interface.
Syntax
ip rip send version {1 | 2 | r1compatible}
1
2
r1compatible
Syntax of the "no" Form
The no form restores the version of update packets that was transmitted by the RIP module:
no ip rip send version
Mode
Interface configuration:
Default
Version 1
Example
The following example sets RIP version 2 for packets sent on FastEthernet interface 1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip rip send version 2
ip split-horizon
This command sets split horizon mode for the packets to be sent by RIP.
Syntax
ip split-horizon
Syntax of the "no" Form
The no form of this command disables the split‐horizon mechanism entirely:
no ip split-horizon
Mode
Interface configuration:
5-130 Configuring the Internet Protocol
RIP version 1.
RIP version 2.
Sends version 2 packets, but transmits these as broadcast packets rather
than multicast packets, so that systems which only understand RIP
version 1 can receive them.
XSR(config-if<xx>)#
XSR(config-if<xx>)#