Frame Relay Clear And Show Commands - Enterasys X-Pedition XSR CLI Cli Reference Manual

Frame Relay Clear and Show Commands

Examples
This example selects sub‐interface Serial 1/0.5 on a serial interface:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#interface serial 1/0.5 multi-point
XSR(config-subif<S1/0.5>)#no shutdown
This example selects a sub‐interface on a T1/E1 card:
XSR(config)#interface serial 2/1
XSR(config-if<S2/1>)#encapsulation frame-relay
XSR(config-if<S2/1>)#no shutdown
XSR(config-if<S2/1>)#interface serial 2/1:12.1 multi-point
XSR(config-subif<S2/1:12.1>)#no shutdown
Frame Relay Clear and Show Commands
clear frame-relay counter
This command clears the statistics of a particular Frame Relay DLCI, or all DLCIs under a
specified Frame Relay sub‐interface, or a Frame Relay port, or all Frame Relay ports on the XSR.
Syntax
clear frame-relay counter [[interface] [interface-num] [dlci dlci-num]]
interface
-num
dlci-num
Mode
EXEC:
clear frame-relay inarp
This command clears the inverse ARP table of one or all Frame Relay ports, causing the Frame
Relay multipoint sub‐interfaces to issue Inverse ARP requests to re‐discover next hop addresses.
Syntax
clear frame-relay inarp [interface][interface-num][dlci] [dlci-num]
9-102 Configuring Frame Relay
The interface or sub‐interface number of the Frame Relay port or sub‐interface
affected by this command. If interface serial interface‐num is not specified, then
this command applies to all Frame Relay ports. If interface‐num specifies a sub‐
interface, then only DLCIs in that particular sub‐interface will be cleared. If
interface‐num calls for an interface, then all DLCIs on the Frame Relay interface
will be cleared.
The specific DLCI whose statistics will be cleared.
XSR>