Igmp Clear And Show Commands - Enterasys X-Pedition XSR CLI Cli Reference Manual

Default
The threshold is 0
Example
The following example sets the source tree switching threshold to 4 kbps:
XSR(config)#ip pim spt-threshold 4

IGMP Clear and Show Commands

clear ip mroute
This command deletes entries from the multicast table.
Syntax
clear ip mroute [group-address][source-address]
group-address
source-address
Mode
EXEC configuration:
show ip igmp groups
This command displays the multicast groups with receivers that are directly connected to the XSR
and were learned through the Internet Group Management Protocol (IGMP).
Syntax
show ip igmp groups [group-address | type number | summary]
group-address
type
number
summary
Mode
EXEC configuration:
Example
The following example displays sample responses:
XSR>show ip igmp groups
Interface name:
IP address of the multicast group.
IP address of the multicast source.
XSR>
Address of the multicast group.
Interface type.
Interface number.
A one‐line, abbreviated summary of each entry in the IGMP groups table.
XSR>
FastEthernet1
IGMP Clear and Show Commands
XSR CLI Reference Guide 7-95