Table of Contents
Advertisement
community-number
Syntax of the "no" Form
The no form of this command removes the commmunity list number:
no community-list community-list-number
Mode
Global configuration:
Example
This example configures IP community list 88. The community numbers specified in the list are
2000, 3000, and 4000 in the first, second, and third instance of the command, respectively. This list
can be referenced within the
BGP routing based on the community attribute. The match will seek updates that include
community numbers 2000, 3000, or 4000.
XSR(config)#ip community-list 88 permit 2000
XSR(config)#ip community-list 88 permit 3000
XSR(config)#ip community-list 88 permit 4000
network
This command specifies the list of networks for the BGP routing process. Networks can be
learned from connected routes or via dynamic routing. The BGP process must be notified about the
networks it will route which con occurs via manual injection of routes into the BGP process with
the
network
code set to IGP.
Network numbers that are injected into BGP by means of the
exist in the IP routing table on the router as static, directly‐connected, or dynamically‐derived
routes. If network numbers do not already exist, they will not be placed into the BGP table, even
though they will appear in the router's configuration.
Syntax
network network-number [mask network-mask]
network-number
mask
Community number as it was defined for this router via the
community
command. Valid values are:
•
Range: 1 to 4,294,967,200.
•
aa:nn: AS number, Community number.
•
internet: the Internet community.
•
no‐export: the community route will not be advertised to an EBGP peer.
•
no‐advertise: the route will not be advertised to any peer.
XSR(config)#
match community
command. Routes originated by BGP via the
Network that BGP advertises.
Used when a network‐mask is explicitly specified for the network‐
number. Without the network‐mask being specified, a default classful
mask is assumed.
command that is part of a route map controlling
network
command have their origin
network
command must already
XSR CLI Reference Guide 6-107
BGP Configuration Commands
set
Advertisement
Table of Contents
