Enterasys X-Pedition XSR CLI Cli Reference Manual page 579

Mode
VPN Interface configuration: XSR(config‐if<xx>)#
Example
The following example configures VPN interface 1 with an IP address, and TOS copy enabled. It
also sets a peer IP address, GRE, and turns on the associated VPN tunnel.
XSR(config)#interface vpn 1
XSR(config-int-vpn)#ip address 20.20.20.1/24
XSR(config-int-vpn)#copy-tos
XSR(config-int-vpn)#service-policy output vpn
XSR(config-int-vpn)#tunnel t1
XSR#(config-tms-tunnel)#set protocol gre
XSR#(config-tms-tunnel)#set peer 10.10.10.2
XSR#(config-tms-tunnel)#set active
XSR#(config-tms-tunnel)#no shutdown
description
This commands describes a VPN interface and any tunnel it contains.
Syntax
description comment
comment
Syntax of the "no" Form
The no form of this command deletes the description described earlier:
no description
Mode
Interface Internet Protocol configuration:
Example
The following example describes ACME_VPN:
XSR(config)#interface vpn 57 multi-point
XSR(config-int<vpn>)#description ACME_VPN
Everything to the end of the line is recorded as a comment. Use quotation marks for
multiple words.
XSR(config-int<vpn>)#
Interface VPN Commands
XSR CLI Reference Guide 14-125