Table of Contents
Advertisement
General Network Management Commands
value
reset
command
commandgroup
Mode
Global configuration:
Defaults
•
Privilege level 0: all statistics (
show clock
•
Privilege levels 1 through 9 ‐ the following EXEC Mode commands are available:
exit, help, isdn, ping, telnet, terminal
users having privilege levels 1 ‐ 9 have no access to Privileged EXEC commands.
•
Privilege levels 10 through 14 ‐ the following Privileged EXEC mode commands are available:
cd, clear, clock, dir, disable, enable, exit, help, isdn, no, ping, pwd,
reload, telnet, terminal, traceroute
15 users can access Global Mode commands.
•
Privilege level 10: all statistics (
running-config, show interface
•
Privilege level 15: other configuration commands such as
rename, write.
•
Any user privilege level automatically inherits all privileges granted to lower privilege levels.
•
Admin privilege level (15) cannot be changed.
•
Privilege for special user admin: 15
•
Only administrators can add, delete, or change user rights.
•
Only administrators can change privilege levels for commands.
•
Users can change their own passwords but not their privilege levels.
Examples
This example sets the privilege level for the
XSR(config)#privilege configure level 6 username
This example resets the privilege level for the
XSR(config)#privilege configure reset username
This example sets the privilege level for the
XSR(config)#privilege router-rip level 13 neighbor
1-10 Network Management
Privilege level associated with the mode of operation ranging from 0 to
15 (highest).
Resets the privilege level to the default.
Command within that mode to set a privilege for.
Set of commands to associate with a privilege. For example, T1
Controller group commands.
XSR(config)#
show
, etc.
show
Only an admin can issue these commands.
) commands with low‐level security such as
, and
traceroute
, and
verify
) commands with higher level security such as
, etc.
username
command in Global mode to level 6:
username
command in Global mode to the default:
neighbor
command in Router RIP mode to level 13:
show version
. Unless explicitly defined,
. Unless explicitly defined, only level
configure, copy, delete,
,
disable,
show
Advertisement
Table of Contents
