Table of Contents
Advertisement
frame-relay lmi-n391dte
This command sets the full status‐polling interval when the Digital Terminal Equipment (DTE)
interface is configured to set the full status message‐polling interval.
Syntax
frame-relay lmi-n391dte num_ka-exchanges
num_ka-exchanges
Syntax of the "no" Form
The no form of this command restores the default interval value:
no frame-relay lmi-n391dte
Default
6
Mode
Interface configuration:
Example
This example establishes that a status inquiry will be sent every five seconds and that one of every
ten status inquiries generated will request a full status response from the Frame Relay switch. The
other nine status inquiries will request keep‐alive exchanges only:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dte
XSR(config-if<S1/0>)#frame-relay lmi-n391dte 10
XSR(config-if<S1/0>)#frame-relay lmi-t391dte 5
XSR(config-if<S1/0>)#no shutdown
frame-relay lmi-n392dce
This command sets the error threshold on a Data Communications Equipment (DCE) interface.
Syntax
frame-relay lmi-n392dce threshold
threshold
Syntax of the "no" Form
The no form of this command removes the current setting:
no frame-relay lmi-n392dce
Number of keep‐alive exchanges to occur before requesting a full
status message, ranging from 1 to 255.
XSR(config-if<xx>)#
Error threshold, ranging from 1 to 10.
Frame Relay Commands
XSR CLI Reference Guide 9-89
Advertisement
Table of Contents
