Enterasys X-Pedition XSR CLI Cli Reference Manual page 400

Multilink Show Commands
Rx Stats
Total
Discard Seq
Error
FlistFull
Seq<Exp
NoBgnFlg
AddFgFail
CleanQ
Tx Stats
Total
Discard CleanQ
Qfull
show ppp interface multilink/dialer memberlink
This command displays general member link statistics under MLPPP or specific member link
statistics if specified.
Syntax
show ppp interface multilink <1-32767> memberlink [type number]
show ppp interface dialer <1-256> memberlink [type number]
Parameters
type
number
Mode
EXEC:
Sample Output
The following example displays output of this command:
********** MLPPP Member Link Stats **********
Multilink 1: MLPPP is Admin Up / Oper Up
Group Num: 1
LCP
8-130 Configuring the Point-to-Point Protocol
Sum of fragments received for this class.
Sum of received fragments discarded for this class because sequence number is
out of order.
Sum of received fragments discarded for this class because fragment list is full.
Sum of received fragment discarded for this class because sequence number is
less than expected.
Sum of received fragments discarded for this class because no BEGIN flag
detected.
Sum of received fragments discarded for this class because fragment cannot be
added into fragment list.
Sum of received fragments discarded for this class while cleaning the interface.
Sum of fragments transmitted for this class.
Sum of transmission fragments discarded for this class while cleaning port.
Sum of transmission fragments discarded for this class because transmission
queue is full.
Interface type serial. If serial is specified, only this serial member link statistics
display, otherwise all member link data display.
Card/port numbers for a serial interface. Card/port:channel numbers for serial
channel groups.
XSR>
State: OPENED