snmp-server Commands
sha
auth-password
priv
des56
priv-password
access
access-list
Syntax of the "no" Form
Use the no form of this command to remove a user:
no
snmp-server user username groupname {v1 | v2c | v3}
Mode
Global configuration:
Example
The example below configures ljc of the v3authgrp SNMP group with strong v3 level security, MD5
authentication, and the password acorntree:
XSR(config)#snmp-server user ljc v3 auth v3authgrp md5 acorntree
snmp-server view
This command creates or updates a view entry. The XSR provides one default view which is used
for all community commands which do not specify a view parameter. The v1default view includes
the internet tree and excludes snmpUsmMIB and snmpVacmMIB. You can remove this view with
the
no snmp-server v1default
Syntax
snmp-server view view-name {oid-tree | treeEntryName} {included | excluded}
view-name
oid-tree
treeEntryName
included
excluded
Syntax of the "no" Form
Use the no form of this command to remove a view entry:
no snmp-server view view-name
1-30 Network Management
HMAC SHA algorithm used for authentication.
The user's authentication password. At least 8 characters is required.
Specifies the privacy setting.
CBC‐DES privacy encryption algorithm.
Privacy password for the user. A minimum of 8 characters is required.
Specifies an access‐list associated to this user.
Standard IP access‐list allowing access to this user.
XSR(config)#
command.
Label for the view record that you update/create.
Object identifier of the subtree to be included/excluded from the view.
This parameter can be either a numeric OID or a well‐known MIB name
listed in Table
1‐2 on page 1‐31, or a MIB name followed by a numeric
OID (i.e., system.6 for sysLocation). Names are case‐sensitive.
Name of the sub‐tree equivalent to the object OID tree.
This view includes the specified OID tree.
This view excludes the specified OID tree.