Enterasys X-Pedition XSR CLI Cli Reference Manual page 446

Dialer Interface Clear and Show Commands
Phone numbers: <2400:12>
Connection speed/type: <64k>/<On Demand>
Dialer maps configured on Interface <Dialer2>:
Next hop IP address: <20.20.20.2>
Phone numbers: <2400>
Connection speed/type: <not set>/<On Demand>
show dialer sessions
This command displays information regarding dialer sessions.
Syntax
show dialer sessions
Mode
EXEC:
Sample Output
The following is sample output from the
XSR#show dialer sessions
ID
0001
0002
0003
0004
Parameter Descriptions
ID
Interface
Type
State
MLPPP
Phone No
Phys Intf
10-92 Configuring the Dialer Interface
XSR#
Interface Type
Dialer1 On Demand
Dialer1 Multilink
Dialer1 Incoming
Dialer0 On Demand
Dial session ID number ‐ node‐wide and unique. Range: 1 to 512.
Dialer interface number which has requested the dial session.
Dial session type:
•
•
•
•
•
IDLE, WAITING, CALLING or CONNECTED.
MLPPP group number to which the dial session belongs.
Number used to dial out.
Dialer pool port used to build a switched link with remote peer.
show dialer sessions
State
IDLE
CONNECTED
CONNECTED
WAITING
On demand: session that handles on demand connection requests
Backup: session which is requested by a backed up interface or
watched route
Multilink: dial session requested by a multilink group used for
backup or on demand
Callback: dial callback session.
Bandwidth: a Bandwidth on Demand requested connection.
command:
MLPPP Phone# Phys Intf
001
001 3100 Serial 2/0:30
001 Serial 2/0:12
000 2600 D-Serial 1/0:0