Table of Contents
Advertisement
Firewall Feature Set Commands
enable disable
Syntax of the "no" Form
The no form of this command cancels a scheduled load and unlocks the firewall config CLI:
XSR(config)#no ip firewall load delay
Mode
Global configuration:
Examples
The following example verifies the firewall configuration is correct:
XSR(config)#ip firewall load trial
This example schedules a load in five days, three hours and 20 minutes:
XSR(config)#ip firewall load delay 5 03:20
After the load is performed, the following message will display:
XSR(config)#<186>Mar 17 22:30:22 10.10.10.20 FW: Firewall Shutdown and Restarted
<186>Mar 17 22:30:22 10.10.10.20 FW: Firewall: The Firewall has just executed a
delayed load command successfully
ip firewall logging
This command defines logging object parameters that apply to the firewall log operation. Logging
is cumulative. For example, by selecting Level 3, the firewall will generate all messages from
Levels 3 to 0. If you set logging to Level 0, the number of messages will be minimal.
Levels 0 to 3 are designated for attacks, denies and other system‐related logs such as memory
failures. Levels 4 to 7 are designated for permits, warnings and other informational logs. There are
very few debug level logs so in order to see permits a setting of 5 or 6 is sufficient.
16-120 Configuring Security
Executes or terminates the firewall load.
Note: If the command is issued when a load delay is pending, the following error message displays:
Load: Configuration locked due to scheduled load delay
XSR(config)#
Advertisement
Table of Contents
