Show Sntp - Enterasys X-Pedition XSR CLI Cli Reference Manual

no sntp-server
This command disables the SNTP server.
Syntax
no sntp-server
Mode
Global configuration:

show sntp

This command displays the current status of the SNTP server.
Syntax
show sntp
Output
XSR>show sntp
SNTP server
30.10.1.22
1.1.1.1
Client Status: Enabled
Server Status: Enabled
Poll Interval: 512
Server requests:
Current Time: 00:36:42-UTC-Tuesday, 30-MAR-2004
Parameter Descriptions
SNTP server
30.10.1.22
Stratum
#Polls
Last Receive
Active
Unicast
Client Status
Server Status
Poll Interval
Server requests
Clock is synchronized, stratum 10, reference is <RTC or last synchronized reference>
XSR(config)#
Stratum #Polls
10 1
0 0
125
The IP address of the designated SNTP server.
Level of the network where the clock is located. The primary stratum is
generally considered at stratum 1. The XSR default stratum is 10.
Sum of client requests to the SNTP server.
Hour, minute and second of the last client reply from the SNTP server.
Whether the SNTP is in active state.
SNTP server point‐to‐point mode.
State of the SNTP client ‐ enabled or disabled.
State of the SNTP server ‐ enabled or disabled.
Interval in seconds between client requests to the SNTP server.
Sum of client requests to the server.
Last Receive
00:36:39 Active
Never...
SNTP Commands
Unicast
Unicast
XSR CLI Reference Guide 3-93