Arp Commands - Enterasys X-Pedition XSR CLI Cli Reference Manual

XSR>show ip pbr-cache
Source
192.168.1.1
192.168.1.1
192.168.1.1
Parameter Descriptions
Source
Destination
Age
IP Protocol
TCP/UDP Port
ICMP Code
show route-map pbr
This command displays the Policy Map Table you have configured. This is the Global Route Map
that is used for Policy Based Routing.
Syntax
show route-map pbr
Mode
EXEC configuration:
Sample Output
The following is sample output when the command is issued:
XSR>show route-map pbr
route-map pbr, sequence 10
Match clauses:
ip address 102
ip address 101
Set clauses:
next-hop 192.168.27.33
interface FastEthernet1

ARP Commands

arp
This command adds permanent (static) entries to the ARP (Address Resolution Protocol) table.
ARP converts an IP address into a physical address. The XSR permits adding/deleting one or all
ARP entries.
Destination Age(sec)
192.168.27.1 109
192.168.27.33 70
192.168.27.33 50
Source IP address of the packet.
Destination IP address of the packet.
Seconds left for the lifetime of the cache.
IP Protocol number.
TCP/UDP Port number.
ICMP code number.
XSR>
IP Prot TCP/UDP Port
1 8
255
6 (23, 23)
XSR CLI Reference Guide 5-149
ARP Commands
ICMP Code