Table of Contents
Advertisement
Syntax of the "no" Form
The no form of this command disables the feature:
no dialer caller number
Mode
Dialer Interface configuration:
Example
The following example configures the dialer caller numbers to screen:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#dialer caller 5084712345
dialer idle-timeout
This command specifies the idle timeout interval before the XSR disconnects the line. The timeout
trigger is based on outbound traffic only.
Syntax
dialer idle-timeout seconds
seconds
Syntax of the "no" Form
Use the no form of this command to reset the idle timeout to the default:
no dialer idle-timeout
Mode
Dialer Interface configuration:
Default
120 seconds
Examples
The following example resets the idle‐timeout:
Note: If the ISDN switch does not provide the calling number, callback will fail.
Caution: This command must be invoked on the called side of a link with a 0 value to ensure the
link is not dropped after 120 seconds by the called side.
Interval before disconnecting the line, ranging from 0 to 2,147,483 seconds.
Specifying 0 disables the timeout.
XSR(config-if<Dx>)#
XSR(config-if<Dx>)#
DOD/BOD Commands
XSR CLI Reference Guide 10-99
Advertisement
Table of Contents
