Enterasys X-Pedition XSR CLI Cli Reference Manual page 269

Syntax
vrrp group ip ipaddress
group
ipaddress
Syntax of the "no" Form
The no form of this command removes the virtual IP address on a port:
no vrrp group ip ipaddress
Defaults
• No VR configured
• Group: 1
Mode
Interface configuration:
Examples
The following example adds and enables virtual group1 on F1. The VRRP group is 1 and IP
address 10.0.1.20 is the address of the virtual router.
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#vrrp 1 ip 10.0.1.20 or vrrp 1 ip 10.0.1.20
The following example removes virtual IP address 10.0.1.20 from virtual group 1 on F1. The VRRP
group is 1 and IP address 10.0.1.20 is the address of the virtual router.
XSR(config-if<F1>)#no vrrp 1 ip 10.0.1.20 or vrrp ip 10.0.1.20
vrrp <group> master-respond-ping
This command allows the Virtual Router (VR) master to respond to an ICMP ping regardless of
actual IP address ownership. RFC‐2338 specifies that a VR master that is not the actual address
owner should not respond to ICMP ping associated with the virtual IP address. This configuration
should be consistent on all interfaces participating in a VR.
Syntax
vrrp <group> master-respond-ping
group
Syntax of the "no" Form
The no form of this command disables the functionality:
no vrrp group master-respond-ping
VR group number. If you do not specify an input group number, the default
group number will be used. Limit: 11 addresses per VR, 44 per router.
IP address of the VR.
XSR(config-if<xx>)#
VR group number, ranging from 1 to 255.
Virtual Router Redundancy Protocol Commands
XSR CLI Reference Guide 5-193