Enterasys X-Pedition XSR CLI Cli Reference Manual page 582

Tunnel Commands
• set protocol -
mode or network extension mode. Refer to page 14‐130 for the command definition.
set user -
•
for the command definition.
Syntax
tunnel tunnel-name
tunnel-name
Syntax of the "no" Form
The no form of this command deletes the tunnel:
no tunnel tunnel-name
Mode
Interface Internet Protocol configuration:
Next Mode
Tunnel configuration:
Example
The following example adds the tunnel ACME_VPN:
XSR(config)#interface vpn 57 multi-point
XSR(config-int<vpn>)#tunnel ACME_VPN
XSR#(config-tms-tunnel)#
set active
This command enables the tunnel.
Syntax
set active
Syntax of the "no" Form
The no form of this command disables the tunnel:
no set active
Default
Enabled
14-128 Configuring the VPN
Defines the VPN tunneling protocol used when the tunnel is created: client
Username employed when connecting to the remote peer. Refer to page 14‐131
The name assigned to the tunnel.
XSR#(config-tms-tunnel)#
XSR(config-int-vpn)#