Enterasys X-Pedition XSR CLI Cli Reference Manual page 264

Network Address Translation Commands
global-ip
tcp | udp
local-port
global-port
Syntax of the "no" Form
The no form of the command removes a single static translation entry:
no ip nat source static local-ip global-ip
Mode
Global configuration:
Example
The following example configures a static NAT system:
XSR(config)#ip nat source static 192.178.15.97 10.10.10.5
ip nat translation
This command changes the interval after which translations time out.
Syntax
ip nat translation {timeout | udp-timeout | tcp-timeout | icmp-timeout}[seconds]
| [never]
timeout
udp-timeout
tcp-timeout
icmp-timeout
seconds
never
Syntax of the "no" Form
The no command configures default timeout values:
no ip nat translation {timeout | udp-timeout | tcp-timeout | icmp-timeout}
[seconds] | [never]
Mode
Global configuration:
5-188 Configuring the Internet Protocol
Translated IP address.
This value implies that his is a port‐specific static NAT.
Source port of outgoing packets and destination port of incoming packets.
Destination port of outgoing packets and source port of incoming packets.
XSR(config)#
Dynamic NAT interval (not overload translations).
UDP port interval.
TCP port interval.
ICMP traffic interval.
Period after which port translation expires.
No expiration.
XSR(config)#