Table of Contents
Advertisement
DOD/BOD Commands
n
interval
m
re-enable
t
forever
Mode
Interface configuration:
Defaults
•
Attempt: 1 (no redial)
•
Interval: 10 seconds
•
Re‐enable: 5 seconds
Example
Assuming you have configured Serial interfaces 1/0, 1/1, and 1/2 as part of dialer pool 1, the
following example sets the dialer to attempt dialing each interface five times (if all attempts are
unsuccessful), indefinitely until the dial trigger is reset or a connection is successfully established.
XSR(config)#interface dialer 1
XSR(config-if<D1>)#dialer pool 1
XSR(config-if<D1>)#dialer redial attempts 5 forever
dialer remote-name
This command specifies, for a dialer interface, the PPP authenticated user name of the remote
router that is calling in.
Syntax
dialer remote-name username
username
Mode
Dialer Interface configuration:
Example
The following example sets the authentication name for the remote router on Dialer interface 7:
XSR(config)#interface dialer 7
XSR(config-if<D1>)#dialer remote-name "Auth West"
10-102 Configuring the Dialer Interface
Number of redial attempts made if dial-up or ISDN connection establishment
fails, ranging from 1 to 65535.
Period between redial attempts.
Interval period, ranging from 5 to 2678400 seconds (31 days).
Period for which the port is disabled if all redial tries fail.
Re-enable period, ranging from 5 to 2678400 seconds.
Number of redial attempts applied to all members of the dialer pool in a never-
ending loop if dial-up or ISDN connection establishment is unsuccessful. Redial
attempts end if the dial trigger is reset or the connection is established.
XSR(config-if<xx>)#
Case-sensitive character string identifying the remote device with a maximum
length of 255 characters.
XSR(config-if<Dx>)#
Advertisement
Table of Contents
