Enterasys X-Pedition XSR CLI Cli Reference Manual page 467

Note: This command is valid only after the pri-group command was issued.
Syntax
isdn switch-type switch-type {basic-dms100 | basic-ni1 | basic-ntt | basic-net3 |
primary-net5 | primary-ni2 | primary-5ess | primary-dms100 | primary-ntt}
BRI Switch Types:
basic-dms100
basic-ni1
basic-5ess
basic-ntt
basic-net3
PRI Switch Types:
primary-net5
primary-ni2
primary-5ess
primary-dms100
primary-ntt
Syntax of the "no" Form
The no form of this command deletes the three serial interfaces:
no isdn switch-type
Defaults
• BRI: basic‐net3
• PRI: primary‐net5
• E1: primary‐net5
• T1: primary‐ni2
• J1: primary‐ntt
Mode
BRI/PRI Interface configuration:
North America legacy ISDN switch.
National ISDN 1 switch for North America.
North America legacy ISDN switch: not supported.
Switch for ISDN in Japan.
ETSI‐compliant switch for Euro‐ISDN.
ETSI‐compliant switch for Euro‐ISDN.
T1 National ISDN switch type (T1 default).
T1 NOAM legacy switch.
T1 NOAM legacy switch.
T1/J1 ISDN switch for Japan.
XSR(config-if<BRI/PRI-xx>)#
ISDN Commands
Book Title goes here 11-89