Ip Ospf Priority - Enterasys X-Pedition XSR CLI Cli Reference Manual

Mode
Interface configuration:
Example
The following example imposes OSPF passive on Fast Ethernet interface 1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip ospf passive
ip ospf poll-interval
This command sets the OSPF polling interval on Multipoint and Point‐to‐Point interfaces. The
default value allows the adjacency to be established per the default Hello interval.
Syntax
ip ospf poll-interval <interval>
interval
Syntax of the "no" Form
The no form of this command removes the poll interval:
no ip ospf poll-interval
Mode
Interface configuration:
Example
This example configures the poll interval to 12 times the default hello interval (10 seconds):
XSR(config-if<S1/0:0>)#ip ospf poll-interval 120

ip ospf priority

This command sets the OSPF priority value for router interfaces. The priority value is
communicated between routers by means of hello messages and this value influences the election
of a designated router.
Syntax
ip ospf priority number
number
Syntax of the "no" Form
The no form of this command sets the value to the default:
no ip ospf priority
XSR(config-if<xx>#
Poll period, ranging from 1 to 65,535.
XSR(config-if<xx>)#
Specifies the router priority, ranging from 0 to 255.
OSPF Commands
XSR CLI Reference Guide 5-97