Ip Rip Receive Version - Enterasys X-Pedition XSR CLI Cli Reference Manual

ip rip receive version

This command sets RIP v1 or v2 for update packets received on the port.
Syntax
ip rip receive version [1] [2]
1
2
Syntax of the "no" Form
The no form of this command restores the default version of the RIP module update packets that
are accepted on the interface:
no ip rip receive version
Mode
Interface configuration:
Default
Accept both RIP version 1 and 2
Example
This example sets both RIP versions 1 and 2 for update packets received on FastEthernet port 1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip rip receive version 1 2
Figure 5-3
Distance Router 1-Router x2+1 hops
Backup
Router 1
Serial 1/0
Serial 1/1
Distance Router1-Rx2 hops
RIP version 1.
RIP version 2.
XSR(config-if<xx>)#
Offset Example
Router x
INTERNET
INTERNET
RIP Commands
XSR CLI Reference Guide 5-129