Table of Contents
Advertisement
•
ip rip triggered-on-demand
page 192 for the command definition.
ip rip max-retransmissions
This command sets the maximum number of retransmissions to be sent.
Syntax
ip rip max-retransmissions number
number
Syntax of the "no" Form
The no command resets the maximum retransmissions value to the default:
no ip rip max-retransmissions
Mode
Interface configuration:
Default
36
Example
This example sets the number of retransmissions to 50:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#ip address 1.0.0.0 255.0.0.0
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#ip rip triggered-on-demand
XSR(config-if<S1/0>)#ip rip max-retransmissions 50
XSR(config)#router rip
XSR(config-router)#network 1.0.0.0
ip rip polling-interval
This command sets the polling interval for triggered RIP requests. If a request gets no response
after retransmissions peak, requests will continually transmit at intervals set by this command.
Syntax
ip rip polling-interval interval
interval
Number of retransmissions, ranging from 2 to 120.
XSR(config-if<xx>)#
Note: The polling interval should be less than the dialer spoofing timeout.
Polling period ranging from 10 to 600 seconds.
‐ Enables the functionality on the specified interface. Refer to
Triggered on Demand RIP Commands
XSR CLI Reference Guide 5-143
Advertisement
Table of Contents
